Parking Assist Control Module: Service and Repair

Parking Aid Module (PAM)









Removal and Installation

1. NOTE: Module configuration is only required if a new Parking Aid Module (PAM) is being installed.

Upload the PAM configuration information to the scan tool. For additional information, refer to Programmable Module Installation (PMI) in Module Configuration Programmable Module Installation (PMI).

2. Remove the engine cover. For additional information, refer to Interior Trim and Ornamentation Service and Repair.

3. If replacing the Parking Aid Module (PAM), proceed as follows:
- Disconnect the electrical connectors.

- Remove the PAM push-pins.

- Remove the PAM.

4. If replacing the parking aid speaker only, proceed as follows:
- Disconnect the parking aid speaker electrical connector.

- Disengage the parking aid speaker clips.

- Remove the parking aid speaker.

5. To install, reverse the removal procedure.
- Download the PAM configuration information. For additional information, refer to Module Configuration Programmable Module Installation (PMI).