Electronic Brake Control Module: Service and Repair
Anti-Lock Brake System (ABS) Module
Removal and Installation
1. If installing a new ABS module, connect the scan tool and upload the module configuration information from the ABS module. For additional information, refer to Module Configuration Special Tool(s) Used With Diagnostics.
2. Remove the Air Cleaner (ACL). For additional information, refer to Intake Air Distribution and Filtering Intake Air System Components - Exploded View.
3. NOTE: Do not disconnect the hoses from the power steering reservoir.
Remove the 4 bolts and position the power steering fluid reservoir and bracket aside.
- To install, tighten the bolts to 28 Nm (21 lb-ft).
4. Remove the 3 bolts and position the degas bottle aside.
- To install, tighten the bolts to 10 Nm (89 lb-in).
5. Disconnect the ABS module electrical connector.
- Release the lock tab.
- Pull the connector from the module.
6. Remove the 4 screws and the ABS module.
- To install, tighten the screws to 5 Nm (44 lb-in).
7. To install, reverse the removal procedure.
1. If a new ABS module was installed, download the module configuration information from the scan tool. For additional information, refer to Module Configuration Special Tool(s) Used With Diagnostics.
2. For vehicles equipped with Roll Stability Control (RSC(R)), carry out the IVD Initialization sequence. Follow the scan tool directions.