Windshield Washer Pump: Service and Repair

Washer Pump and Reservoir

Removal

1. Remove the battery tray. For additional information, refer to Battery, Mounting and Cables Battery Tray.

2. Remove the windshield wiper reservoir nut and bolt.
- To install, tighten to 4 Nm (35 lb-in).

3. Disconnect the filler hose from the reservoir.

4. Disconnect the washer pump electrical connector and wiring harness locator.

5. WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.

NOTE: If necessary, drain the windshield washer reservoir after removal.

Disconnect the windshield washer hose and remove the washer pump and reservoir.

6. NOTICE: Do not operate the windshield washer pump before filling the windshield washer reservoir. Failure to do so could result in premature pump failure.

To install, reverse the removal procedure.