Pinpoint Test R: Squeak/Rattle/Chucking Noise From Door

Handles, Locks, Latches and Entry Systems

Pinpoint Tests

Pinpoint Test R: Squeak/Rattle/Chucking Noise From Door

This pinpoint test is intended to diagnose the following:

- Door alignment
- Striker adjustment
- Door latch


PINPOINT TEST R: SQUEAK/RATTLE/CHUCKING NOISE FROM DOOR

-------------------------------------------------
R1 CHECK FOR ANY LOOSE COMPONENTS


- Remove the door trim panel. Refer to Interior Trim and Ornamentation Doors.
- Inspect inside the door for any loose components.
- Are there any loose components inside the door?

Yes
REPAIR as necessary. TEST the system for normal operation.

No
GO to R2.

-------------------------------------------------
R2 CHECK THE STRIKER ADJUSTMENT


- Check the adjustment of the striker. Refer to Body Closures Adjustments.
- Is the striker adjusted correctly?

Yes
GO to R3.

No
ADJUST the striker as necessary. TEST the system for normal operation.

-------------------------------------------------
R3 CHECK THE DOOR ALIGNMENT


- Check the alignment of the door. Refer to Body Closures Adjustments.
- Is the door aligned correctly?

Yes
GO to R4.

No
ADJUST the door as necessary. TEST the system for normal operation.

-------------------------------------------------
R4 CHECK THE LATCH OPERATION AFTER LUBRICATION


- Lubricate the door latch. Refer to Latch Lubrication Procedures.
- Using a screwdriver, fully close the latch (2 clicks).




- Operate the door latch and listen for the noise.
- Is the original noise still present after the latch is lubricated?

Yes
INSTALL a new door latch. REFER to Front Door Latch Front Door Latch or Door Latch - Side and Rear, Single Latch Door Latch - Side and Rear, Single Latch. TEST the system for normal operation.

No
The concern was caused by an insufficiently lubricated door latch.

-------------------------------------------------