Power Steering Pump: Service and Repair

Power Steering Pump













Removal and Installation

NOTICE: While repairing the power steering system, care should be taken to prevent the entry of foreign material or failure of the power steering components may occur.

1. Using a suitable suction device, remove the power steering fluid from the fluid reservoir.

2. Disconnect the supply hose.

3. Remove the pressure line clamp plate bolt and disconnect the pressure line from the pump.
- Discard the bolt.

- To install, tighten the new bolt to 25 Nm (18 lb-ft).

4. Remove the 3 power steering pump bolts and the pump.
- To install, tighten to 25 Nm (18 lb-ft).

5. To install, reverse the removal procedure.

6. Fill the power steering system. For additional information, refer to Steering System Power Steering System Filling.