Pinpoint Test AF: DTC U0121:00

Electronic Locking Differential (ELD) System

Pinpoint Test AF: DTC U0121:00

Normal Operation

- DTC U0121:00 (Lost Communication With Anti-Lock Brake System (ABS) Control Module: No Sub-Type Information)- sets in continuous memory in the TCCM (Transfer Case Control Module) if data messages received from the ABS module over the HS-CAN (High Speed Controller Area Network) are missing for 5 seconds or longer with ignition in RUN and battery voltage in range. For a complete list of all network messages, refer to Information Bus.

This pinpoint test is intended to diagnose the following:

- ABS module

- TCCM (Transfer Case Control Module)

PINPOINT TEST AF : DTC U0121:00

AF1 VERIFY THE CUSTOMER CONCERN

- Ignition ON.

- Verify there is an observable symptom present.

Is an observable symptom present?

Yes
GO to AF2.
No
The system is operating normally at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.

AF2 CHECK THE COMMUNICATION NETWORK

- Ignition ON.

- Enter the following diagnostic mode on the scan tool: Network Test.

- Carry out the network test.

Does the ABS module pass the network test?

Yes
GO to AF3.
No
REFER to Information Bus.

AF3 RETRIEVE THE RECORDED DTCs FROM THE ABS MODULE SELF-TEST

- Check for recorded DTCs from the ABS module self-test.

Is DTC B11E8:16 (B1318) or DTC B11E8:17 (B1317) recorded?

Yes
REFER to Antilock Brakes / Traction Control Systems.
No
GO to AF4.

AF4 RETRIEVE THE RECORDED DTCs FROM THE TCCM (Transfer Case Control Module) SELF-TEST

- Check for recorded DTCs from the TCCM (Transfer Case Control Module) self-test.

Is DTC P0562:00 or P0563:00 recorded?

Yes
GO to Pinpoint Test M Pinpoint Test M: DTC P0562:00 Or P0563:00.
No
GO to AF5.

AF5 RECHECK THE TCCM (Transfer Case Control Module) DTCs
NOTE: If new modules were installed prior to the DTC being set, the module configuration may be incorrectly set during the PMI (Programmable Module Installation) or the PMI (Programmable Module Installation) may not have been carried out.

- Clear the DTCs.

- Wait 10 seconds.

- Repeat the TCCM (Transfer Case Control Module) self-test.

Is DTC U0121:00 still present?

Yes
INSTALL a new ABS module. CLEAR the DTCs. REPEAT the TCCM (Transfer Case Control Module) self-test.

If DTC U0121:00 is still present, INSTALL a new TCCM (Transfer Case Control Module). REFER to Transfer Case Control Module (TCCM) .
TEST the system for normal operation.
No
The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.