Powertrain Controls - ECM/PCM

Diagnostic Chart:

Wiring Diagram:

CIRCUIT DESCRIPTION
CKT 440 is the battery feed for the PCM.

DTC 53 WILL SET WHEN
The ignition is "ON" and the PCM terminal "E16" voltage is greater than 19.5 volts for 2 seconds.

ACTION TAKEN (PCM WILL DEFAULT TO)
The pressure control solenoid is turned "OFF," 3-2 control solenoid is turned "OFF," transmission shifts immediately to third gear, and Torque Converter Clutch (TCC) operation will be inhibited. (The setting of additional diagnostic trouble codes may result.)

DTC 53 WILL CLEAR WHEN
Fault condition no longer exists, and the ignition switch is cycled "OFF" then "ON."

DTC CHART TEST DESCRIPTION
Number(s) below refer to circled number(s) on the diagnostic charts.
1. Normal battery voltage is between 9-15 volts.
2. This test checks if the generator is faulty under load conditions. If the voltage is greater than 15 volts, refer to Charging System.

DIAGNOSTIC AIDS
^ CKT 440 supplies battery voltage to the PCM.
^ Charging the battery with a battery charger and jump-starting an engine may set DTC 53. If DTC(s) set when an accessory is operated, check for faulty connections or excessive current draw. Refer to Charging System for circuit details.
^ Check for faulty connections at the starter solenoid or fusible link.