Dimmer Switch Assembly - Assemble - Off Vehicle

Dimmer Switch Assembly - Assemble - Off Vehicle

Tools Required

J 41352 Modular Column Holding Fixture




1. Install the dimmer switch assembly (3) onto the ignition and dimmer switch mounting stud (1).
2. Install the end of the dimmer switch actuator rod into the dimmer switch assembly (3).
3. Install the hexagon nut (2).
4. Tighten the hexagon nut (2) finger tight.
5. Install the washer head screw (4).
6. Tighten the washer head screw (4) finger tight.




7. Install a 3/32 inch drill bit into the hole (1) on the dimmer switch assembly to limit travel.
8. Position the dimmer switch assembly onto the column and push it against the dimmer switch actuator rod to remove all the lash.





Notice: Refer to Fastener Notice in Cautions and Notices.

9. Secure the following:

* Secure the washer head screw (4) into the dimmer switch assembly (3).

Tighten the washer head screw to 4 Nm (35 lb in).

* Secure the hexagon nut (2) onto the dimmer and ignition switch mounting stud (1).

Tighten the hexagon nut to 4 Nm (35 lb in).

10. Remove the 3/32 inch drill bit from the dimmer switch assembly (3).




11. Remove the steering column and J 41352 from the vise.