Rear Suspension

Torque Rod Replacement

Removal Procedure




1. Set the parking brake.
2. Block the front and the rear wheels.

Important: In order to maintain proper driveline alignment, some models may use spacers or shims between the torque rod and torque rod mounting bracket, or between the mounting bracket and the frame crossmember. Note the number and position of spacers or shims for proper installation.


3. Remove the following components from the torque mounting brackets and the axle bracket:

* The nuts
* The washers
* The bolts

4. Remove the torque rod.

Installation Procedure





Important: Use the same number of spacers or shims as previously used in order to ensure original driveline alignment.


1. Install the torque rod to frame mounting brackets.

Notice: Refer to Fastener Notice .

2. Install the following components:

* The torque rod bolt
* The washers
* The nuts

Tighten the torque rod nut to 85 Nm (63 lb ft).

3. Install the torque rod to the axle mounting bracket.
4. Install the following components:

* The torque rod bolts
* The washers
* The nuts

Tighten the torque rod nut to 175 Nm (130 lb ft).