Flexplate/Torque Converter Vibration Test

Flexplate/Torque Converter Vibration Test
To determine and correct a torque converter vibration, use the following general procedure to achieve the best possible torque converter-to-flywheel balance. Refer to Transmission Replacement for detailed procedure steps as appropriate.

Caution:
Refer to Battery Disconnect Caution in Service Precautions.

1. Disconnect the battery.
2. Raise the vehicle. Refer to Vehicle Lifting.
3. Remove the starter motor bolts and position the starter motor aside. Refer to Starter Motor Replacement.





4. If present, remove the converter housing inspection cover.





5. Remove the torque converter bolts.





6. Rotate the torque converter one bolt position.

7. Notice:
Refer to Fastener Notice in Service Precautions.

Install the torque converter bolts.

Tighten the bolts to 60 Nm (44 ft. lbs.).

8. Install the starter motor and starter motor bolts. Refer to Starter Motor Replacement.

9. Caution:
Refer to Battery Disconnect Caution in Service Precautions.

Connect the battery.
10. Start the vehicle and test for vibration again. If vibration is still present, repeat the testing procedure. Repeat this procedure until you obtain the best possible balance.