Glow Plug Replacement - Bank 2

Glow Plug Replacement - Bank 2

Removal Procedure





1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (With Single Battery) (Service and Repair)Battery Negative Cable Disconnection and Connection (With Auxiliary Battery) (Service and Repair)Battery Negative Cable Disconnection and Connection (With Dual Batteries) (Service and Repair) .
2. Remove the left wheelhouse panel. Refer to Front Wheelhouse Liner Replacement - Left Side (Chevrolet) (Service and Repair)Front Wheelhouse Liner Replacement - Left Side (GMC) (Service and Repair) .
3. Remove the engine wiring harness nut(s) from the glow plug(s).
4. Remove the engine wiring harness lead(s) from the glow plug(s).


Note

If a glow plug is replaced and the tip is missing or burned off, the cylinder head must be removed and all debris must be cleaned out of the cylinder.

5. Remove the glow plug(s) from the cylinder head.



Installation Procedure





Caution: Refer to Fastener Caution (Fastener Caution) .
1. Install the glow plug(s) to the cylinder head and tighten to 18 Nm (13 lb ft) .
2. Install the engine wiring harness lead(s) to the glow plug(s).
3. Install the engine wiring harness nut(s) to the glow plug(s) and tighten to 1.7 Nm (15 lb in) .
4. Install the left wheelhouse panel. Refer to Front Wheelhouse Liner Replacement - Left Side (Chevrolet) (Service and Repair)Front Wheelhouse Liner Replacement - Left Side (GMC) (Service and Repair) .
5. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (With Single Battery) (Service and Repair)Battery Negative Cable Disconnection and Connection (With Auxiliary Battery) (Service and Repair)Battery Negative Cable Disconnection and Connection (With Dual Batteries) (Service and Repair) .