B3873

DTC B3873

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Diagnostic System Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Strategy Based Diagnosis) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Diagnostic Procedure Instructions) provides an overview of each diagnostic category.

DTC Descriptor
DTC B3873 02
- Front Washer Relay Circuit Short to Ground

Diagnostic Fault Information





Circuit/System Description

The body control module (BCM) controls the windshield washer fluid pump based on an input from the window wiper/washer switch. The BCM monitors the washer switch through the windshield washer switch signal circuit. When the wash switch is closed, ground is supplied to the front washer switch signal circuit. When this is the case, the BCM will command the windshield washer fluid pump and the low speed wipers on.

Conditions for Running the DTC

* Ignition ON.
* The system voltage is between 9-16 V.

Conditions for Setting the DTC

A short to ground is detected in the windshield washer relay control circuit.

Action Taken When the DTC Sets

Washer operation is suspended.

Conditions for Clearing the DTC

A current DTC clears when the diagnostic runs and passes.

Reference Information
Schematic Reference

Wiper/Washer Schematics (Electrical Diagrams)
Connector End View Reference

Component Connector End Views (Connector Views)
Description and Operation

Wiper/Washer System Description and Operation (Description and Operation)
Electrical Information Reference

* Circuit Testing (Circuit Testing)
* Connector Repairs (Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (Wiring Repairs)

Scan Tool Reference

Control Module References (Programming and Relearning) for scan tool information

Circuit/System Verification

Operate the front washers using the S80 Window Wiper/Washer Switch. Verify the G24 Windshield Washer Pump activates.

Circuit/System Testing

1. Ignition OFF, disconnect the harness connector at the X50A Fuse Block - Underhood.
2. Disconnect the harness connector X4 at the K9 Body Control Module.
3. Test for less than 5 ohm between the control circuit terminal 4 K at the X50A Fuse Block - Underhood and the control circuit terminal 14 X4 at the K9 Body Control Module.

• If the value is not within the specified range, test the control circuit for a short to voltage or an open/high resistance.
• If the circuit tests normal, test or replace the K9 Body Control Module.

4. Test for infinite resistance between the control circuit terminal 4 K at the X50A Fuse Block - Underhood and ground.

• If the value is not within the specified range, test the control circuit for a short to ground.

5. If all circuits test normal, test or replace the X50A Fuse Block - Underhood.

Component Testing

Relay Test
1. Ignition OFF, disconnect the harness connector B at the X50A Fuse Block - Underhood.
2. Test for 60-200 ohm between control circuit terminal K 4 and ground circuit terminal C 8.

• If all circuits test normal, test or replace the X50A Fuse Block - Underhood.

Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.

* Control Module References (Programming and Relearning) for BCM replacement, setup, and programming
* Windshield Washer Pump Replacement (Equinox) (Service and Repair)Windshield Washer Pump Replacement (Terrain) (Service and Repair)