Coolant Heater Replacement

Coolant Heater Replacement (LH9)

Removal Procedure




1. Drain the cooling system/engine block. Refer to Cooling System Draining and Filling (Static Fill) Cooling System Draining and Filling (Static Fill)Cooling System Draining and Filling (Vac N Fill) Cooling System Draining and Filling (Vac N Fill).
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.
3. Disconnect the coolant heater cord electrical connector.





Note: Do not score the surface of the engine block hole when removing the coolant heater.

4. Remove the coolant heater from the engine block.
5. Remove any burrs, sealer, or other rough spots.

Installation Procedure




1. If reusing the old coolant heater, apply thread sealant GM P/N 12346004 (Canadian P/N 10953480), or equivalent to the threads.

Caution: Refer to Fastener Caution Fastener Caution.

2. Install the coolant heater to the engine block. Tighten the coolant heater to 50 Nm (37 lb ft).




3. Connect the coolant heater cord electrical connector.
4. Lower the vehicle.
5. Fill the cooling system/engine block. Refer to Cooling System Draining and Filling (Static Fill) Cooling System Draining and Filling (Static Fill)Cooling System Draining and Filling (Vac N Fill) Cooling System Draining and Filling (Vac N Fill).