Navigation System - Voice Recognition Malfunction

Navigation System - Voice Recognition Malfunction

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.

* Diagnostic Procedure Instructions Diagnostic Procedure Instructions provides an overview of each diagnostic category.

Reference Information

Schematic Reference

OnStar Schematics OnStar Schematics

Connector End View Reference

Component Connector End Views 1-2 Shift Solenoid (SS) Valve (M30)

Electrical Information Reference

* Circuit Testing Circuit Testing

* Connector Repairs Connector Repairs

* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections

* Wiring Repairs Wiring Repairs

Circuit/System Testing

1. Verify the OnStar(R) voice recognition is operating normally.

• If the OnStar(R) voice recognition is inoperative, refer to OnStar Microphone Malfunction OnStar Microphone Malfunction.

2. Ignition OFF, disconnect the radio harness connector X2 and CIM harness connector X2.

3. Test for less than 1 volt on the voice recognition audio signal high circuit radio harness connector terminal 4 and ground.

• If greater than specified value, test the circuit for a short to voltage.

4. Test for greater than 1 ohm between the voice recognition audio signal high circuit radio harness connector terminal 7 and ground.

• If less than specified value, test the circuit for a short to ground.

5. Test for less than 1 ohm between the voice recognition audio signal high circuit radio harness connector terminal 7 and the voice recognition audio high signal circuit CIM harness connector terminal 1.

• If greater than specified value, test the circuit for an open/high resistance.

6. Test for less than 1 volt on the voice recognition audio signal low circuit radio harness connector terminal 15 and ground.

• If greater than specified value, test the circuit for a short to voltage.

7. Test for greater than 1 ohm between the voice recognition audio signal low circuit radio harness connector terminal 15 and ground.

• If less than specified value, test the circuit for a short to ground.

8. Test for less than 1 ohm between the voice recognition audio signal low circuit radio harness connector terminal 15 and the voice recognition audio signal low circuit CIM harness connector terminal 2.

• If greater than specified value, test the circuit for an open/high resistance.

9. If all circuits test normal, replace the radio.

Repair Instructions

Perform the Diagnostic Repair Verification Verification Tests after completing the diagnostic procedure.

Control Module References Control Module References for radio replacement, setup, and programming