Planetary Gears and Output Shaft

REMOVE OR DISCONNECT

1. Front planetary gear assembly from output shaft assembly.

2. Rear planetary thrust washer from front planetary gear assembly.
3. Reverse brake flange from front planetary gear assembly.
4. Reverse brake plates and discs from front planetary gear.

5. Reverse brake reaction plate from front planetary gear.

6. Snap ring, one-way clutch and one-way clutch rear thrust washer from front planetary gear.

7. Compress snap ring and remove front planetary ring gear, thrust bearing and rear planetary race.

8. Rear planetary thrust washer, rear planetary gear and rear planetary sun gear from rear planetary ring gear.

9. Snap ring from inner shaft and separate inner shaft from rear planetary ring gear.
10. Thrust bearing assembly from rear planetary ring gear.

INSTALL OR CONNECT
1. Thrust bearing assembly to rear planetary ring gear.
2. Inner shaft to rear planetary ring gear and install snap ring.
3. Thrust bearing to rear planetary ring gear. Lubricate with J 36850.

4. Rear planetary sun gear, rear planetary gear and rear planetary thrust washer to rear planetary ring gear.
5. Rear planetary race and thrust bearing. Lubricate with J 36850.
6. Compress snap ring and install front planetary ring gear.

7. One-way clutch rear thrust washer, one-way clutch and snap ring to from front planetary gear.
8. Reverse brake reaction plate to front planetary gear.

INSPECT
With reverse brake reaction plate held stationary turn front planetary gear clockwise to check that it locks and then counterclockwise to check that it turns smoothly. If a problem is detected disassemble and INSPECT.

9. Reverse brake plates and discs to front planetary gear in the following order:
A. Plate
B. Disc
C. Plate
D. Disc
E. Plate
F. Disc
G. Plate
H. Disc
10. Reverse brake flange to front planetary gear assembly with beveled side down.
11. Rear planetary thrust washer to front planetary gear assembly. Lubricate with J 36850.
12. Front planetary gear assembly to output shaft assembly.