Oil Pump and Torque Converter Housing

INSTALL OR CONNECT

^ Tools Required:
- J 8001 Dial Indicator Set
- J 26900-13 Magnetic Base





1. Apply A/T fluid to new O-ring and O-ring to overdrive case.
2. Torque converter housing to transmission case; secure with three bolts.

Tighten
- Converter housing position (A) bolts to 36 N.m (27 lb. ft.).
- Converter housing position (B) bolts to 58 N.m (43 lb. ft.).





3. Apply J 36850 to thrust front race and install it to overdrive clutch drum.
4. Apply J 36850 to thrust bearing and race and install them to oil pump.





5. Apply A/T fluid to outer O-ring of oil pump and install oil pump to transmission case; secure with seven bolts. Align holes to oil pump with hole in overdrive case.

Tighten
- Oil pump bolts to 22 N.m (16 ft. lbs.).





INSPECT
Apply low air pressure to each oil circuit hole and check operation of internal components.
1. Overdrive clutch.
2. Overdrive brake.
3. Forward clutch.
4. Direct clutch.
5. B1 brake (Second coast brake).
6. B2 brake (Second brake).
7. Reverse brake.





MEASURE
- MEASURE output-shaft end play using J 8001 and a J 26900-13.
- Standard clearance is 0.3-0.9 mm (0.012-0.035-inch).