Overdrive Clutch Drum and Overdrive Case Assemblies

INSTALL OR CONNECT

^ Tools Required:
- J 26900-5 Vernier Caliper
- J 36850 Transjel Transmission Assembly Lubricant

1. Apply J 36850 to thrust rear race and install it to rear of overdrive case.





2. Overdrive case assembly to transmission case aligning cutout on overdrive case with cut out in transmission case.





3. Apply J 36850 to thrust planetary rear washer and install it to overdrive planetary gear.
4. Apply J 36850 to thrust planetary ring front race and install it to planetary ring gear.
5. Overdrive clutch and planetary gear assembly into overdrive case.





MEASURE
- MEASURE height difference between overdrive case and overdrive clutch drum using a J 26900-5. Standard height difference is 2.0 mm (0.078-inch). If height difference is less than standard height difference, remove overdrive clutch assembly and reinstall.