Planetary Gears and Output Shaft

INSTALL OR CONNECT

^ Tool Required:
- J 36850 Transjel Transmission Assembly Lubricant





1. Output shaft thrust bearing race and thrust bearing to transmission case. Lubricate with J 36850.





2. Brake applying tube and leaf spring to transmission case. Align lug on brake applying tube with cut out in transmission case.





3. Planetary gear and output shaft assembly to transmission case.





MEASURE
- Clearance between reverse brake plate and lugs of transmission case. Standard clearance should be 0.72-2.50 mm (0.029-0.098-inch). If clearance is less than standard range, check for improper installation, dust or fluid is on the reverse brake disc. If clearance is more than standard range, replace reverse brake disc, reverse brake plate or reverse backing plate.





4. Reverse brake reaction plate to transmission case. Align notch in reverse brake reaction plate with leaf spring.





5. Snap ring to the front of the reverse brake reaction plate.