Transmission Range Switch

INSTALL OR CONNECT
1. Transmission range switch to transmission by:
A. Turn manual shaft rearward.
B. Turn it back two notches and set it to "N" range.
C. Transmission range switch to transmission securing with one bolt. Do not tighten bolt fully.
D. Lock washer and set nut.

Tighten
- Transmission range switch set nut to 5 N.m (44 lb. in.).

2. Bend claws of lock washer over set nut.





3. With neutral reference line and cut out in transmission range switch aligned. Tighten transmission range switch retaining bolt.

Tighten
- Transmission Range switch bolt to 5 N.m (44 lb. in.).

4. Manual lever to manual shaft; secure with one washer and one nut.

Tighten
- Manual shaft lever nut to 13 N.m (115 lb. in.).

5. Vent hose to vent elbow at top of transmission case; secure with one clamp.
6. New O-ring to fluid filler and tube to transmission case; secure with one bolt.
7. Fluid level indicator to filler tube.
8. Remove the J 41626 with the transmission case from the J 3289-20.
9. Remove the J 41626 from the transmission case.





10. Install the three remaining bolts into the torque converter housing.

Tighten
- Converter housing position (A) bolts to 36 N.m (27 lb. ft.).
- Converter housing position (B) bolts to 58 N.m (43 lb. ft.).