DTC 32-3x

DTC 32-3x (32-30 to 32-39, 32-3A to 32-3F): Short to Another Wire or Decreased Resistance in Front Passenger's Side Airbag Inflator

Special Tools Required
- SRS inflator simulator 07SAZ-TB4011A
- SRS simulator lead E 07XAZ-S1A0200
- SRS short canceller 070AZ-SAA0100

1. Erase the DTC memory.
2. Turn the ignition switch ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.

Does the SRS indicator stay on, and is DTC 32-3x indicated?

YES - Go to step 3.

NO - Intermittent failure, system is OK at this time. Go to Troubleshooting Intermittent Failures. If another DTC is indicated, go to the Trouble Code Descriptions.

3. Turn the ignition switch OFF. Disconnect the battery negative cable, and wait for 3 minutes.




4. Disconnect the SRS floor harness 2P connector (A) from the front passenger's side airbag (B).
5. Connect the SRS inflator simulator (2 Ohm connector) and simulator lead E to the SRS floor harness.
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
8. Check for a DTC.

Is DTC 32-3x indicated?

YES - Go to step 9.

NO - Short to another wire in the front passenger's side airbag inflator; replace the front passenger's side airbag.

9. Turn the ignition switch OFF. Disconnect the battery negative cable, and wait for 3 minutes.
10. Disconnect both seat belt tensioner 2P connectors.
11. Disconnect SRS unit connector B (28P) from the SRS unit. Do not disconnect the special tool from the SRS floor harness 2P connector.
12. Disconnect the SRS inflator simulator from SRS simulator lead E.
13. Connect a SRS short canceller (070AZ-SAA0100) to the No. 23 and No. 24 terminals of SRS unit connector B (28P).




14. Check resistance between each terminal of the SRS simulator lead E and body ground. There should be an open circuit or at least 1 MOhms.

Is the resistance as specified?

YES - Faulty SRS unit; replace the SRS unit.

NO - Short in the SRS floor harness; replace the SRS floor harness.