DTC 32-8x

DTC 32-8x (32-80 to 32-89, 32-8A to 32-8F): Short to power in Front Passenger's Side Airbag Inflator

Special Tools Required
- SRS inflator simulator 07SAZ-TB4011A
- SRS simulator lead E 07XAZ-S1A0200

1. Erase the DTC memory.
2. Turn the ignition switch ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.

Does the SRS indicator stay on, and is DTC 32-8x indicated?

YES - Go to step 3.

NO - Intermittent failure, system is OK at this time. Go to Troubleshooting Intermittent Failures. If another DTC is indicated, go to the Trouble Code Descriptions.

3. Turn the ignition switch OFF. Disconnect the battery negative cable, and wait for 3 minutes.




4. Disconnect the SRS floor harness 2P connector (A) from the front passenger's side airbag (B).
5. Connect the SRS inflator simulator (2 Ohm connector) and the simulator lead E to the SRS floor harness.
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
8. Check for a DTC.

Is DTC 32-8x indicated?

YES - Go to step 9.

NO - Short to power in the front passenger's side airbag inflator, replace the front passenger's side airbag.

9. Turn the ignition switch OFF. Disconnect the battery negative cable, and wait for 3 minutes.
10. Disconnect both seat belt tensioner 2P connectors.
11. Disconnect SRS unit connector B (28P) from the SRS unit. Do not disconnect the special tool from the SRS floor harness 2P connector.
12. Reconnect the battery negative cable.
13. Disconnect the SRS inflator simulator from SRS simulator lead E.
14. Turn the ignition switch ON (II).




15. Check for voltage between each terminal of SRS simulator lead E and body ground. There should be 0.5 V or less.

Is the voltage as specified?

YES - Faulty SRS unit; replace the SRS unit.

NO - Short to power in the SRS floor harness; replace the SRS floor harness.