DTC 65

DTC 65: Brake Fluid Level
1. Check the brake fluid level.
Is the level correct?
YES - Go to step 2.
NO - Check for leaks in the brake system. If no leaks are found, inspect the brake lining and replace any worn brake pads.
2. Disconnect the gauge assembly connector B (22P), and brake fluid level switch 2P connector.





3. Check for continuity between terminal No. 19 of the gauge assembly connector B (22P) and body ground.
Is there continuity?
YES - Repair short to ground in the wire between the gauge assembly connector B and the brake fluid level switch.
NO - Go to step 4.
4. Check the brake fluid level switch.
Is the switch OK?
YES - Do the troubleshooting for the gauge assembly.
NO - Replace the brake fluid level switch.