DTC 1-1

DTC 1-1: Open in driver's airbag inflator

1. Erase the DTC memory.
2. Turn the ignition switch ON (II), and check that the SRS indicator light comes on for about 6 seconds and then goes off.

Does the SRS indicator light stay on?

YES - Go to step 3.

NO - Intermittent failure, system is OK at this time. Go to Troubleshooting Intermittent Failures.

3. Turn the ignition switch OFF. Disconnect the battery negative cable, and wait for 3 minutes.




4. Disconnect the driver's airbag 4P connector from the cable reel 4P connector (A).
5. Connect the special tool (2 Ohms connectors) to the cable reel 4P connector.
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
8. Read the DTC.

Is DTC 1-1 or DTC 1-2 indicated?

YES - Go to step 9.

NO - Open or increased resistance in the driver's airbag inflator; replace the driver's airbag.

9. Disconnect the battery negative cable, and wait for 3 minutes.




10. Disconnect the front passenger's airbag 4P connector (A) from the SRS main harness 4P connector (B).




11. Disconnect both seat belt tensioner 2P connectors (A) from the side wire harness 2P connectors (B).




12. Disconnect SRS unit connector A (18P) from the SRS unit.




13. Check resistance between the No.7 and the No.16 terminals and between the No.2 and the No.11 terminals of SRS connector A (18P). There should be 2.0 - 3.0 Ohms.

Is the resistance as specified?

YES - Faulty SRS unit or poor contact at SRS unit connector A (18P) and the SRS unit. Check the connection. If the connection is OK, replace the SRS unit.

NO - Open or increased resistance in the SRS main harness or cable reel; replace the SRS main harness or cable reel.