C1355

DTC C1355 MULTI SENSOR ID'S RECEIVED

COMPONENT LOCATION
Refer to DTC C1126. C1126

GENERAL DESCRIPTION
Refer to DTC C1126. C1126

DTC DESCRIPTION
This DTC indicates that ECU receives two or more sensor IDs. -OR- Received sensor ID is already located to another position. The most likely cause is the refractor which surrounds the vehicle. (steel wall etc.)

DTC DETECTING CONDITION:

MONITOR SCANTOOL DATA
1. Connect "TPMS exciter" or Scantool to Data Link Connector(DLC).
2. Select "TPMS DIAGNOSIS" mode.
3. Select the "FULL" mode of "SENSOR LEARN/LOCA. STATUS" function.
4. Monitor the parameter of four WE sensor's ID on the "TPMS exciter" or Scantool.





5. Was ID of all sensor registered each?
YES
- Fault is intermittent. It has been repaired and TPMS receiver module memory is not cleared yet.
- Go to "'Verification of vehicle Repair" procedure.
NO
- Check for vehicle interference sources.
- Repair if necessary and then go to "Verification of Vehicle Repair" procedure.

VERIFICATION OF VEHICLE REPAIR
Refer to DTC C1121. C1121