B1583

Component Location





General Description

Personal IC Card system(hereinafter referred to PIC system) makes user more convenient by locking/unlocking door and starting engine without using mechanical key or remote controller. The push switch , attached to the Knob of the MSL, sends driver's intension for starting. If driver with PIC FOB presses push switch, SMART KEY ECU searches FOB with valid ID inside and Once valid FOB is founded, SMART KEY ECU sends release signal to MSL. Then MSL is released by operating solenoid in MSL. After checking the change lever position is "P", SMART KEY ECU makes engine be able to be started by transmitting key confirmation information to engine ECM.

DTC Description

The ECM sets DTC 'B1583' if the parking switch signal is detected. when the starting KNOB is in "IGN" position and the vehicle speed exceed 3Km/h.

DTC Detecting Condition





Signal Waveform




Fig 1) The Signal Waveform Signal Waveform of PIC
1. trigger : IGN PUSH KNOB
2. LF interior search
3. Release MSL command (measured at the serial interface)
Fig 2) Trigger : gear shift in "P"

Schematic Diagram





Monitor DTC Status

1. Connect scantool to Data Link Connector(DLC).
2. Engine "ON"
3. Operate the vehicle within DTC Enable conditions in General information.
4. Monitor the "PARKING SW " parameter on the scantool.

Specification :"PARKING SW" parameter "OFF"





Fig 3) The current data when the change lever is in "P" position.
Fig 4) DTC 'B1583'
5. Is the monitored parameter within specifications?






W/Harness Inspection
1. Many malfunctions in the electrical system are caused by poor harness and terminals. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.
2. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration,or damage.
3. Has a problem been found?






Signal(Parl Position Switch) Circuit Ground Short Inspection
1. IG KEY : OFF.
2. PIC IMMOBILIZER MODULE connector : Disconnect.
3. Measure resistance between Signal(Park Position Switch) of PIC IMMOBILIZER MODULE harness connector and chassis ground.

Specification :Infinity


4. Is "resistance" display near the specified value?






Component Inspection

Check PIC Immobilizer Module
1. IG KEY : OFF.
2. PIC IMMOBILIZER MODULE connector : Connect.
3. IG KEY: OFF, ENG : ON.
4. Measure voltage between Signal(Park Position Switch) of PIC IMMOBILIZER MODULE harness connector and chassis ground.
* Check the voltage change of signal line with operating park position switch.

Specification :park position switch -> below 0V , OFF -> approx. 12V


5. Is "voltage" display near the specified value?






Verification Of Vehicle Repair

After a repair, it is essential to verifying that the fault has been corrected.
1. Connect scan tool and select "Diagnostic Trouble Codes(DTCs)" mode.
2. Using scantool, Clear DTC.
3. Operate the vehicle within DTC Enable conditions in General information.
4. Are any DTCs present ?