Keyless Entry: Testing and Inspection

Trouble Diagnoses Symptom Chart

NOTE:
^ The unlock and panic alarm operation to multi-remote control system does not activate with the ignition key inserted in the ignition key cylinder.
^ The lock operation of multi-remote control system does not activate with the key inserted in the ignition key cylinder or if one of the doors is opened.





Remote Controller Battery Check





Multi-Remote Control Antenna Check





Power Supply and Ground Circuit Check





Door Switch Check





Key Switch (Insert) Check





Door Unlock Sensor Check





Hazard Reminder Check





Interior Room Lamp Operation Check





ID Code Entry Procedure

Enter the Identity (ID) code manually when:
^ remote controller or control unit is replaced.
^ an additional remote controller is activated.

To enter the ID code, follow the procedures in the image.

NOTE:
^ If you need to activate more than two additional new remote controllers, repeat the procedure "Additional ID code entry" for each new remote controller.
^ If the same ID code that exists in the memory is input, the entry will be ignored.
^ Entry of maximum four ID codes is allowed and any attempt to enter more will be ignored.






Smart Entrance Control Unit Inspection Table