P0107

P0107 Absolute Pressure Sensor

Component Description
The absolute pressure sensor is built into ECM. The sensor ambient barometric pressure and sends the voltage signal to microcomputer.

On Board Diagnosis Logic:

DTC Confirmation Procedure

NOTE: If "DTC Confirmation Procedure" has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

With CONSULT-II
1. Turn ignition switch ON.
2. Select "DATA MONITOR" mode with CONSULT-II.




3. Wait at least 6 seconds.
4. If 1st trip DTC is detected, go to "Diagnostic Procedure".

With GST
Follow the procedure "With CONSULT-II".

Step 1 - 2:

Diagnostic Procedure