P0705

Description





- The PNP switch assemble includes a transmission range switch.
- The transmission range switch detects the selector position and sends a signal to the TOM.

TCM TERMINALS AND REFERENCE VALUE





Remarks: Specification data are reference values.





ON BOARD DIAGNOSIS LOGIC


DIAGNOSTIC TROUBLE CODE (DTC) CONFIRMATION PROCEDURE





CAUTION: Always drive vehicle at a safe speed.

NOTE: If "DIAGNOSTIC TROUBLE CODE CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch "OFF" and wait at least 5 seconds before conducting the next test.

After the repair, perform the following procedure to confirm the malfunction is eliminated.

With CONSULT-II





1. Turn ignition switch "ON".
2. Select "DATA MONITOR" mode for "ENGINE" with CONSULT 11.
3. Start engine and maintain the following conditions for at least 5 consecutive seconds.
VHCL SPEED SE: 10 km/h (6 MPH) or more
THRTL POS SEN: More than 1.3V
Selector lever: D position (OD "ON" or "OFF")

With GST
Follow the procedure "With CONSULT-II ".





Wiring Diagram-AT-PNP/SW

Diagnostic Procedure





1 of 5





2 of 5





3 of 5





4 of 5





5 of 5

Component Inspection
PARK/NEUTRAL POSITION SWITCH











1. Check continuity between terminals 1 and 2 and between terminals 3 and 4, 5, 6, 7, 8, 9 while moving manual shaft through each position.





2. If NG, check again with manual control linkage disconnected from manual shaft of A/T assembly. Refer to step 1.
3. If OK on step 2, adjust manual control linkage.





4. If NG on step 2, remove PNP switch from A/T and check continuity of PNP switch terminals. Refer to step 1.
5. If OK on step 4, adjust PNP switch.
6. If NG on step 4, replace PNP switch.