P1145

DTC P1145 IVT CONTROL POSITION SENSOR




Component Description
Intake valve timing control position sensors are located in the front of
cylinder heads in both bank 1 and bank 2.

This sensor uses a Hall IC.

The cam position is determined by the intake primary cam sprocket concave (in four places). The ECM provides feedback to the intake valve timing control for appropriate target valve open-close timing according to drive conditions based on detected cam position.

Consult-II Scan Tool Reference Value in Data Monitor Mode:

On Board Diagnosis Logic:

DTC Confirmation Procedure

NOTE: If "DTC Confirmation Procedure" has been previously conducted, always turn ignition switch "OFF" and wait at least 10 seconds before conducting the next test.

WITH CONSULT-II
1. Turn ignition switch "ON".
2. Select "DATA MONITOR" mode with CONSULT-II.




3. Maintain the specified conditions for at least 10 seconds.
4. If 1st trip DTC is detected, go to "Diagnostic Procedure".

WITH GST
Follow the procedure "WITH CONSULT-II" above.

EC-IVCSB1-01:

EC-IVCSB2-01:

Wiring Diagram

Diagnostic Procedure Step 1:

Diagnostic Procedure Step 2 - 6:

Diagnostic Procedure Step 7 - 10:

Diagnostic Procedure

Component Inspection

INTAKE VALVE TIMING CONTROL POSITION SENSOR
1. Disconnect intake valve timing control position sensor harness connector.
2. Loosen the fixing bolt of the sensor.
3. Remove the sensor.
4. Visually check the sensor for chipping.










5. Check resistance as shown .
6. If NG, replace intake valve timing control position sensor.