C1205

AWD Actuator Relay
CONSULT-II REFERENCE VALUE IN DATA MONITOR MODE





Data are reference value.

DIAGNOSTIC PROCEDURE
^ Check the following if "4WD ACTUATOR RLY [C1205]" is displayed in self-diagnostic results of CONSULT-II.

1. CHECK AWD SOLENOID SYSTEM
Perform self-diagnosis. Refer to "SELF-DIAG RESULT MODE".
Is the "4WD SOLENOID [C1204]" displayed?
YES >> Perform trouble diagnoses for AWD solenoid. Refer to "AWD Solenoid".
NO >> GO TO 2.

2. CHECK AWD ACTUATOR RELAY SIGNAL
With CONSULT-II
1. Turn ignition switch "ON". (Do not start engine.)








2. Select "DATA MONITOR" mode for "ALL MODE AWD/4WD" with CONSULT-II.
3. Start engine and read out ON/OFF signal of "ETS ACTUATOR".
OK or NG
OK >> GO TO 4.
NG >> GO TO 3.

3. CHECK AWD CONTROL UNIT
Check AWD control unit input/output signal. Refer to "AWD Control Unit Input/Output Signal Reference Values".
OK or NG
OK >> GO TO 4.
NG >> Check AWD control unit pin terminals for damage or loose connection with harness connector. If any items are damaged, repair or replace damaged parts.

4. CHECK DTC
Perform the self-diagnosis, after driving a vehicle for a while.
OK or NG
OK >> INSPECTION END
NG >> Replace AWD control unit.