AWD Actuator Relay

CONSULT-II REFERENCE VALUE IN DATA MONITOR MODE

DIAGNOSTIC PROCEDURE
^ Check the following if 4WD ACTUATOR RLY [C1205] is displayed in self-diagnostic results of CONSULT-II.

1. CHECK AWD SOLENOID SYSTEM
Perform self-diagnosis. Refer to TF-22, SELF-DIAG RESULT MODE. CONSULT-II Setting Procedure
Is the 4WD SOLENOID displayed?
YES >> Perform trouble diagnosis for AWD solenoid. Refer to TF-28, AWD Solenoid. AWD Solenoid
NO >> GO TO 2.

2. CHECK AWD ACTUATOR RELAY SIGNAL
With CONSULT-II
1. Turn ignition switch ON. (Do not start engine.)
2. Select DATA MONITOR mode for ALL MODE AWD/4WD with CONSULT-II.








3. Start engine and read out ON/OFF signal of ETS ACTUATOR.
OK or NG
OK >> GO TO 4.
NG >> GO TO 3.

3. CHECK AWD CONTROL UNIT
Check AWD control unit input/output signal. Refer to AWD Control Unit Input/Output Signal Reference Values.
OK or NG
OK >> GO TO 4.
NG >> Check AWD control unit pin terminals for damage or loose connection with harness connector. If any items are damaged, repair or replace damaged parts.

4. CHECK DTC
Perform the self-diagnosis, after driving a vehicle for a while.
OK or NG
OK >> INSPECTION END
NG >> Replace AWD control unit.