Trunk / Liftgate Switch: Service and Repair

Removal and Installation of Back Door Opener Switch

REMOVAL
1. Remove back door finisher.
2. Remove back door outside finisher. Refer to "BACK DOOR TRIM".
3. Remove licence lamp. Refer to "License Plate Lamp".




4. Cut back door inner panel along with cutting groove line.

CAUTION: When cutting the back door panel, always wear safety glasses, heavy gloves and a dust proof mask to prevent eye and skin irritation from glass fiver splinters.






NOTE: Through hole is as shown in the figure.




5. Disconnect back door opener switch harness connector (and rear view camera if equipped).
6. Remove opener switch from back door through hole.

INSTALLATION
Install in the reverse order of removal.

CAUTION: After installing, check operation.