P0615
DTC P0615 START SIGNAL CIRCUITDescription
TCM prohibits cranking other than at P or N position.
CONSULT-II Reference Value:
On Board Diagnosis Logic
^ This is not an OBD-II self-diagnostic item.
^ Diagnostic trouble code P0615 STARTER RELAY/CIRC with CONSULT-II or 14th judgment flicker without CONSULT-II is detected when starter relay is switched ON other than at P or N position. (Or when switched OFF at P or N position).
Possible Cause
^ Harness or connectors
(Starter relay and TCM circuit is open or shorted.)
^ Starter relay circuit
DTC Confirmation Procedure
CAUTION: Always drive vehicle at a safe speed.
NOTE: If DTC Confirmation Procedure has been previously performed, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.
After the repair, perform the following procedure to confirm the malfunction is eliminated.
WITH CONSULT-II
1. Turn ignition switch ON. (Do not start engine.)
2. Select SELECTION FROM MENU in DATA MONITOR mode for A/T with CONSULT-II and check monitor STARTER RELAY ON/OFF.
3. Start engine.
4. Drive vehicle for at least 2 consecutive seconds.
5. If DTC is detected, go to AT-109, "Diagnostic Procedure".
AT-STSIG-01:
Wiring Diagram - AT - STSIG
Diagnostic Procedure
1. CHECK STARTER RELAY
With CONSULT-II
1. Turn ignition switch ON. (Do not start engine.)
2. Select SELECTION FROM MENU in DATA MONITOR mode for A/T with CONSULT-II and check monitor STARTER RELAY ON/OFF.
Without CONSULT-II
1. Turn ignition switch ON. (Do not start engine.)
2. Check voltage between the IPDM E/R connector and ground.
OK or NG
OK >> GO TO 5.
NG >> GO TO 2.
2. CHECK HARNESS BETWEEN A/T ASSEMBLY HARNESS CONNECTOR AND IPDM E/R CONNECTOR
1. Turn ignition switch OFF.
2. Disconnect A/T assembly harness connector and IPDM E/R connector.
3. Check continuity between A/T assembly harness connector and IPDM E/R connector.
4. If OK, check harness for short to ground and short to power.
5. Reinstall any part removed.
OK or NG
OK >> GO TO 3.
NG >> Repair open circuit or short to ground or short to power in harness or connectors.
3. CHECK TERMINAL CORD ASSEMBLY
1. Remove control valve with TCM.
2. Disconnect A/T assembly harness connector and TCM connector.
3. Check continuity between A/T assembly harness connector terminal and TCM connector terminal.
4. If OK, check harness for short to ground and short to power.
5. Reinstall any part removed.
OK or NG
OK >> GO TO 4.
NG >> Replace open circuit or short to ground and short to power in harness or connectors.
4. DETECT MALFUNCTIONING ITEM
Check the following.
^ Starter relay.
^ IPDM E/R.
OK or NG
OK >> Replace the control valve with TCM.
NG >> Repair or replace damaged parts.
5. CHECK DTC
Perform AT-107, DTC Confirmation Procedure".
OK or NG
OK >> INSPECTION END
NG >> GO TO 2.