P0725
DTC P0725 ENGINE SPEED SIGNALDescription
The engine speed signal is sent from the ECM to the TCM with CAN communication.
CONSULT-II Reference Value:
On Board Diagnosis Logic
^ This is not an OBD-II self-diagnostic item.
^ Diagnostic trouble code P0725 ENGINE SPEED SIG with CONSULT-II or 16th judgment flicker without CONSULT-II is detected when TCM does not receive the ignition signal from ECM during engine cranking or running.
Possible Cause
Harness or connectors
(ECM to TCM circuit is open or shorted.)
DTC Confirmation Procedure
CAUTION: Always drive vehicle at a safe speed.
NOTE: If DTC Confirmation Procedure has been previously performed, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.
After the repair, perform the following procedure to confirm the malfunction is eliminated.
WITH CONSULT-II
1. Turn ignition switch ON. (Do not start engine.)
2. Select SELECTION FROM MENU in DATA MONITOR mode for A/T with CONSULT-II and check monitor VHCL/S SE-A/T, ACCELE POSI and SLCT LVR POSI.
3. Touch START.
4. Start engine and maintain the following conditions for at least 10 consecutive seconds.
VHCL/S SE-A/T: 10 km/h (6 MPH) or more
ACCELE POSI: More than 1.0/8
SLCT LVR POSI: D position
5. If DTC is detected, go to AT-124, "Diagnostic Procedure".
Diagnostic Procedure
1. CHECK CAN COMMUNICATION LINE
Perform the self-diagnosis. Refer to AT-92, SELF-DIAGNOSTIC RESULT MODE. Self-Diagnostic Result Mode
Refer to AT-102, Diagnostic Procedure without CONSULT-II". Displaying & Reading Trouble Codes
Is a malfunction in the CAN communication indicated in the results?
YES >> Check CAN communication line.
NO >> GO TO 2.
2. CHECK DTC WITH TCM
With CONSULT-II
1. Start engine.
2. Select ECU INPUT SIGNALS in DATA MONITOR mode for A/T with CONSULT-II.
3. While monitoring engine speed, check for engine speed change corresponding to wide-open throttle position signal.
OK or NG
OK >> GO TO 3.
NG >> Check the ignition signal circuit.
3. CHECK DTC
Perform AT-123, DTC Confirmation Procedure".
OK or NG
OK >> INSPECTION END
NG >> GO TO 4.
4. CHECK TCM POWER SUPPLY AND GROUND CIRCUIT
Check TCM power supply and ground circuit.
OK or NG
OK >> GO TO 5.
NG >> Repair or replace damaged parts.
5. DETECT MALFUNCTIONING ITEM
Check the following.
^ A/T assembly harness connector pin terminals for damage or loose connection with harness connector.
OK or NG
OK >> Replace the control valve with TCM.
NG >> Repair or replace damaged parts.