Inspection 1: Warning Lamp Does Not Come On When Ignition Switch Is Turned On
Inspection 1: Warning Lamp Does Not Come On When Ignition Switch Is Turned OnDIAGNOSTIC PROCEDURE
1. CHECK SELF-DIAGNOSIS RESULTS
1. With the ignition switch OFF, connect CONSULT-II and CONSULT-II CONVERTER to the data link connector, then turn the ignition switch ON.
2. Select START (NISSAN BASED VHCL).
3. Select BCM on SELECT SYSTEM screen.
NOTE: If the BCM is not indicated, go to GI-39, "CONSULT-II Data Link Connector (DLC) Circuit". Reading and Clearing Diagnostic Trouble Codes
4. Select BCM C/U on SELECT WORK ITEM screen, and select SELF-DIAG RESULTS.
5. Select SELF-DIAG RESULTS on SELECT DIAG MODE screen.
6. Check display contents in self-diagnostic results.
Is CAN COMM CIRCUIT displayed in the self-diagnosis display items?
YES >> Malfunction in CAN communication system. GO TO LAN-3, "Precautions When Using CONSULT-II". Precautions When Using CONSULT-II
NO >> No malfunction. GO TO 2.
2. CHECK COMBINATION METER
^ Check combination meter function.
OK or NG
OK >> GO TO 3.
NG >> Check combination meter.
3. CHECK LOW TIRE PRESSURE WARNING LAMP
^ Disconnect BCM harness connectors M3 and M4.
Does the warning lamp activate?
YES >> Replace BCM.
NO >> Check combination meter and repair or replace.