Self-Diag Result Mode

SELF-DIAG RESULT MODE
Operation Procedure





1. Perform CONSULT-II Start Procedure. Refer to GI-38, "CONSULT-II Start Procedure". Reading and Clearing Diagnostic Trouble Codes
2. Start engine and drive at 30 km/h (19 MPH) or more for approximately 1 minute.
3. Stop vehicle. With engine at idle, touch SELF-DIAG RESULTS. Display shows malfunction experienced since the last erasing operation.

NOTE:
^ The details for TIME are as follow:
- 0: Error currently detected with AWD control unit.
- Except for 0: Error detected in the past and memorized with AWD control unit.
Detects frequency of driving after DTC occurs (frequency of turning ignition switch ON/OFF).

Display Item List: