Operation CHARM: Car repair manuals for everyone.

C1201

DTC C1201 CONTROLLER FAILURE

DIAGNOSTIC PROCEDURE
^ Check the following if "CONTROLLER FAILURE [C1201]" is displayed in self-diagnostic results of CONSULT-III.

1. PERFORM SELF-DIAGNOSIS

With CONSULT-III
1. Turn ignition switch "ON". (Do not start engine.)
2. Select "SELF-DIAG RESULTS" mode for "ALL MODE AWD/4WD" with CONSULT-III.
3. Touch "ERASE".
4. Turn ignition switch "OFF" and wait at least 10 seconds.
5. Perform the self-diagnosis again.
Is the "CONTROLLER FAILURE [C1201]" displayed?
YES >> Replace AWD control unit.
NO >> INSPECTION END