P1211
DTC P1211 TCS CONTROL UNITDescription
The malfunction information related to TCS is transferred through the CAN communication line from "ABS actuator and electric unit (control unit)" to ECM.
Be sure to erase the malfunction information such as DTC not only for "ABS actuator and electric unit (control unit)" but also for ECM after TCS related repair.
On Board Diagnosis Logic
DTC Confirmation Procedure
TESTING CONDITION:
Before performing the following procedure, confirm that battery voltage is more than 10.5 V at idle.
WITH CONSULT-III
1. Start engine and let it idle for at least 60 seconds.
2. Check 1st trip DTC.
3. If 1st trip DTC is detected, go to "Diagnosis Procedure".
Diagnosis Procedure
Go to BRC-13. How to Proceed With Diagnosis