Removal and Installation

SUNROOF MOTOR ASSEMBLY


Removal and Installation


REMOVAL

CAUTION:
- Before removing sunroof motor, check that glass lid is fully closed.
- After removing sunroof motor, do not attempt to rotate sunroof motor assembly as a single unit.
1. Remove the headlining. Refer to Removal and Installation.





2. Disconnect connector (A) and from sunroof motor assembly (1).
Remove sunroof motor assembly mounting bolts (B), and then remove sunroof motor assembly.

INSTALLATION

CAUTION:
Before installing the sunroof motor assembly, be sure to the place the link and wire assembly in the symmetrical and fully closed position.
1. Move the sunroof motor assembly laterally by little so that the gear is completely engaged into the wire on the sunroof unit assembly and mounting surface becomes parallel. Then tighten the sunroof motor assembly with bolts.
2. Install the headlining. Refer to Removal and Installation.