Removal and Installation
A/T SHIFT SELECTOR
2WD : Removal and Installation
REMOVAL
1. Remove control rod from A/T shift selector assembly.
2. Shift the selector lever to "N" position.
3. Remove knob cover (A) below selector lever downward.
4. Pull lock pin (1) out of selector lever knob (2).
5. Remove selector lever knob.
6. Remove console finisher assembly and center console assembly. Exploded View.
CAUTION:
when disconnecting selector lever position indicator connector from shift position switch, never twist or apply an excessive load to the connector.
7. Remove the rear ventilator duct 1 (with rear ventilation). Refer to
Exploded View.
8. Disconnect A/T shift selector harness connector and harness clips.
9. Remove A/T shift selector assembly mounting bolts.
10. Remove A/T shift selector assembly.
11. Remove selector lever position indicator from console finisher assembly.
a. Remove ashtray (front) (1) from console finisher assembly.
b. Remove insert finisher (1) from console finisher assembly.
c. Remove the selector lever position indicator (1).
Black Arrow: Screw
12. Remove harness connector from selector lever position indicator.
13. Remove adapter from A/T shift selector assembly.
14. Remove dust cover and dust cover plate from A/T shift selector assembly.
15. Remove dust cover plate from dust cover.
16. Remove shift lock unit from A/T shift selector assembly.
17. Remove bracket from vehicle floor panel.
INSTALLATION
Note the following, and install in the reverse order of removal.
CAUTION:
Apply multi-purpose grease on the surface that the shift lock unit plate slides vertically.
- When installing control rod to A/T shift selector assembly, refer to "ADJUSTMENT". .