Removal and Installation

HEADLINING


Removal and Installation


REMOVAL
1. Remove the rear seat cushion. Removal and Installation.
2. Remove the rear seatback. Removal and Installation.
3. Remove front seat belt anchor bolt (LH/RH). Exploded View.
4. Remove rear seat belt anchor bolt (LH/RH). Exploded View.
5. Remove front pillar garnish (LH/RH), front kicking plate inner (LH/RH), center pillar lower garnish (LH/RH), center pillar upper garnish (LH/RH), front body side welt (LH/RH), rear body side welt (LH/RH), rear kicking plate inner (LH/RH). Removal and Installation.
6. Remove luggage side lower finisher (LH/RH), luggage side upper finisher (LH/RH). Removal and Installation.
7. Remove the sun-visor (LH).
- Remove sun-visor cap.
- Remove mounting screws.
- Disconnect vanity mirror lamp harness connector (with vanity mirror lamp)





8. With a remover tool, disengage the driver side front roof finisher
(1) fixing pawls and metal clips, disconnect the harness connector (A) and then remove the front roof finisher.

Triangle : Pawl
Square : Metal clip
White arrow : Vehicle front





9. Remove the lane camera cover mounting pawls with a remover tool (A), then remove the lane camera cover (1).

Triangle : Pawl

10. Disconnect inside mirror harness connectors.
11. Remove the sun-visor (RH).
- Remove sun-visor cap.
- Remove mounting screws.
- Disconnect vanity mirror lamp harness connector (with vanity mirror lamp)





12. Remove the passenger side front roof finisher mounting pawls and metal clips with a remover tool (A), then remove the front roof finisher (1).

Triangle : Pawl
Square : Metal clip

13. Remove assist grips.





- With a small flat-bladed screwdriver (A), press the upper side mounting assist grip cap (1) and pull up to remove the mounting assist grip cap from assist grip (2).





- Once the mounting assist grip cap (1) is removed, pull out the assist grip (2) to remove.





14. Disengage the rear monitor finisher fixing clips and pawls with a remover tool (A), disconnect the harness and then remove the rear monitor finisher (1). (With rear monitor assembly only)





15. Insert a small flat-bladed screwdriver (A) into the hole of the sun-visor holder (1), press while rotating approximately 90 degrees to remove.
16. Using remover tool, remove headlining hidden clip at the back side of headlining.





17. Pull down roof console assembly and disengage metal clips (B) and dual-lock fastener (A).

CAUTION:
Roof console assembly is crimped from the back of headlining. Remove it by disengaging the crimped area of back of roof console assembly after removing headlining from the vehicle.

Square : Metal clip

18. Remove headlining (1) from back door.






CAUTION:
- When removing, 2 workers are required.
- Never bend headlining when removing.
- Be careful not to scratch or damage any part of the body while taking out the headlining.
19. Remove the following parts after removing headlining.
- Roof console assembly. Exploded View.
- Map lamp assembly. Removal and Installation.
- Personal lamp assembly. Removal and Installation.
- Headlining harness.

INSTALLATION
Install in the reverse order of removal.

CAUTION:
- As for guide, install first sun-visor holder (LH/RH) and then the rear hidden clips at the back side of headlining.
- Be careful not to bend the headlining when installing.