Removal and Installation
A/T SHIFT SELECTOR
Removal and Installation
REMOVAL
1. Shift the selector lever to "P" position.
2. Remove control rod from A/T shift selector.
3. Shift the selector lever to "N" position.
4. Remove knob cover (A) below selector lever downward.
5. Pull lock pin (1) out of selector lever knob (2).
6. Remove selector lever knob.
7. Remove center console assembly. Exploded View.
CAUTION:
When disconnecting selector lever position indicator connector from shift position switch, never twist or apply an excessive load to the connector.
8. Remove rear ventilator duct 1. Exploded View, "Exploded
View".
9. Disconnect A/T shift selector harness connector.
10. Remove harness clips from A/T shift selector assembly.
11. Shift the selector lever to "P" position.
12. Remove A/T shift selector assembly mounting bolts.
13. Slightly lift the A/T shift selector assembly (1) and slide it rightward. Then pull it out in the diagonally right direction.
14. Remove adapter from A/T shift selector assembly.
15. Remove dust cover and dust cover plate from A/T shift selector assembly.
16. Remove dust cover from dust cover plate.
17. Remove shift lock unit from A/T shift selector assembly.
18. Remove brackets from vehicle floor panel.
19. Remove selector lever position indicator from console finisher assembly.
a. Remove indicator assembly from console finisher assembly. Exploded View.
b. Remove insert finisher from indicator assembly.
c. Remove selector lever position indicator.
INSTALLATION
CAUTION:
Apply multi-purpose grease on the pin surface (that slides after installing a collar) of the pivot pin.
Note the following, and Install in the reverse order of removal.
- Refer to the followings when installing selector lever knob to A/T shift selector assembly.
1. Insert lock pin to selector lever knob.
2. Install selector lever knob over selector lever until a click is felt.
CAUTION:
- Install it straight, and never tap or apply any shock to install it.
- Never press selector button.
- When installing control rod to A/T shift selector assembly, refer to "ADJUSTMENT". 7AT RE7R01A.