Removal and Installation

REAR DOOR GLASS


Removal and Installation


REMOVAL
1. Remove rear door finisher. Removal and Installation.
2. Remove rear door sash inner cover.
3. Remove rear door inside seal.





4. Remove the rear door grip bracket (1) fixing bolts (B) and then remove the rear door grip bracket.
5. Disconnect the rear door speaker harness connector (A).
6. Remove the sealing screen with a cutter tool.

NOTE:
Cut the butyl-tape so that some parts of the butyl-tape do not remain on the sealing screen, if the sealing screen is reused.





7. Remove the TORX bolt fixing the corner piece assembly lower side to the door panel as shown in the figure with tool (A).





8. Remove partially the door side glass run (1), then remove the bolt (A) fixing the corner piece assembly (2) upper side to the door panel as show in the figure with a tool.
9. Remove the rear door lower sash from the glass upper side.
10. Reconnect the rear door power window switch.





11. Operate the power window switch to raise or lower the door window until the glass mounting bolts can be seen.
12. Remove the rear door glass mounting bolts.

Black arrow : Bolt






13. Hold securely the rear door glass and pull it out of the sash to remove the door glass.

INSTALLATION
Install in the reverse order of removal.