Compressor/Pump: Service and Repair

REAR LOAD LEVELING AIR SUSPENSION COMPRESSOR ASSEMBLY


Removal and Installation

Rear Load Leveling Air Suspension System











REMOVAL
1. Use CONSULT-III "EXHAUST SOLENOID" active test to release the air pressure from the rear load leveling air suspension system.
2. Disconnect the electrical connectors for the rear load leveling air suspension compressor assembly.
3. Unclip the rubber cover to access the rear load leveling air suspension compressor assembly.





4. Disconnect the rear load leveling air suspension hoses at the rear load leveling air suspension compressor assembly.
- To disconnect the hoses, push in on the lock ring using a suitable tool and pull the hose out.





5. Remove the four bolts that mount the rear load leveling air suspension compressor assembly to the underbody.

INSTALLATION
Installation is in the reverse order of removal.





- To connect the rear load leveling air suspension hoses, the lock ring must be fully seated in the fitting. Insert the hose (B) into the lock ring (A) until the lock ring (A) is touching the hose (B) as shown. Pull on the hose to check that it is securely inserted.