Ride Height Sensor: Service and Repair

HEIGHT SENSOR


Removal and Installation

Rear Load Leveling Air Suspension System











REMOVAL
1. Use CONSULT-III "EXHAUST SOLENOID" active test to release the air pressure from the rear load leveling air suspension system.
2. Disconnect the electrical connector for the height sensor.





3. Remove the two height sensor bolts and height sensor arm bracket bolt.
4. Remove the height sensor.

INSTALLATION
Installation is in the reverse order of removal.
1. Start the engine.
2. Use CONSULT-III to perform "STANDARD HEIGHT LEVEL" work support function.
3. Using data monitor of CONSULT-III, verify "HEIGT CALC" is at 0 mm.
4. Check the vehicle height. . If vehicle height is not within
� 10 mm (0 � 0.39 in) of the specification, perform the initialization procedure. Procedures.