Front Bumper: Service and Repair

FRONT BUMPER


Removal and Installation












REMOVAL
1. Remove the side screws from the front fascia assembly.
2. Remove the screws from the front of fender protector. Service and Repair.
3. Remove the fog turn/fog lamp finisher and the fog turn/fog lamp.
- Disconnect the harnesses.
4. Disconnect the sonar sensor, if equipped harness connector under the front fascia assembly.
5. Remove the fasteners, release the clips and remove the front fascia assembly.
6. Remove the plastic clips and remove the upper energy absorber.
7. Remove the upper bumper reinforcement.
8. Remove the plastic clips and remove the lower energy absorber.
9. Remove the front bumper stays and the front bumper side brackets, LH and RH.
10. Disconnect the sonar sensors, if equipped from the sonar sensor retainers, if equipped.
11. Remove the sonar sensors, if equipped and harness from the front fascia assembly.
- Disconnect the sonar sensors, if equipped from the harness.
- Remove the sonar sensor retainers, if equipped from the front fascia assembly.

INSTALLATION
Installation is in the reverse order of removal.