7AT RE7R01B TP Sensor

P1705 TP SENSOR





Description
- The accelerator pedal position sensor is installed on the upper end of the accelerator pedal assembly.
- The accelerator pedal position sensor detects the accelerator position.
- The accelerator pedal position sensor transform the accelerator pedal position into output voltage, and emit the voltage signal to the ECM.
- The TCM receives accelerator pedal position signal from the ECM via CAN communication.




DTC Logic

DTC DETECTION LOGIC






DTC CONFIRMATION PROCEDURE

CAUTION:
Always drive vehicle at a safe speed.
1.PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
- GO TO 2.
2.CHECK DTC DETECTION
With CONSULT-III
1. Start the engine.
2. Select "SLCT LVR POSI" and "VHCL/S SE-A/T" in "Data Monitor" in "TRANSMISSION".
3. Drive vehicle and maintain the following conditions for 5 seconds or more.

SLCT LVR POSI : D
VHCL/S SE-A/T : 5 km/h (3 MPH) or more

4. Perform "Self Diagnostic Results" in "TRANSMISSION".
Is "P1705" detected?
YES - Go to SEE Diagnosis Procedure.
NO - INSPECTION END




Diagnosis Procedure
1.CHECK DTC OF ECM
With CONSULT-III
1. Turn ignition switch ON.
2. Perform "Self Diagnostic Results" in "ENGINE".
Is any DTC detected?
YES - Check DTC detected item. Testing and Inspection.
NO - GO TO 2.
2.CHECK DTC OF TCM
With CONSULT-III
Perform "Self Diagnostic Results" in "TRANSMISSION".
Is any DTC other than "P1705" detected?
YES - Check DTC detected item. Testing and Inspection.
NO - GO TO 3.
3.CHECK INTERMITTENT INCIDENT
Intermittent Incident.
Is the inspection result normal?
YES - Replace control valve & TCM. Exploded View.
NO - Repair or replace damaged parts.