Luggage Side Lower Finisher

LUGGAGE FLOOR TRIM


LUGGAGE SIDE LOWER FINISHER : Removal and Installation


REMOVAL
1. Lift up the seat base, tilt seatback forward, and fold down second seat forward.
2. Remove second seat belt anchor. Removal And Installation.
3. Remove third seat. Removal And Installation.
4. Remove third seat belt anchor. Removal And Installation.
5. Remove luggage floor board center and both luggage lower boards. Luggage Floor Rear Board.
6. Remove luggage rear plate. Luggage Rear Plate.





7. Remove rope hook (1) mounting bolt using a socket wrench (A), and then remove rope hook.





8. Disengage luggage side lower finisher fixing clip (1) using a small flat-bladed screwdriver (A) as shown by the arrow in the figure, and then remove clip.
9. Remove luggage side lower finisher.





1. Disengage luggage side lower finisher (1) fixing clips and pawls.

Circle : Clip
Triangle : Pawl

2. Disconnect luggage room power socket harness connector (LH side only).
3. Disconnect fold down switch harness connector (RH side only).
4. Disconnect reclining switch harness connector (LH and RH).
5. Remove luggage side lower finisher.

INSTALLATION
Note the following items, and install in the reverse order of removal.

CAUTION:
- Visually check the clips and pawls for deformation and damage during installation. Replace with new ones if necessary.
- When installing luggage side lower finisher, check that clips and pawls are securely fitted in body panel holes, and press them in.