Front Pillar Garnish

BODY SIDE TRIM


FRONT PILLAR GARNISH : Removal and Installation


CAUTION:
- When removing, always use a remover tool that is made of plastic.
- Never damage the body.

REMOVAL
1. Release front pillar garnish portion of front body side welt.





2. Disengage assist grip cap (1) fixing pawls using a flat-bladed screwdriver (A) as shown in the figure, and then remove assist grip mounting bolts and assist grip (2).

CAUTION:
Apply protective tape (B) to the assist grip to protect from damage.

Triangle : Pawl





3. Disengage front pillar garnish (1) fixing clip and metal clip using a remover tool (A) as shown by the arrow in the figure, and then remove front pillar garnish.

Circle : Clip
Square : Metal clip


INSTALLATION
Note the following items, and install in the reverse order of removal.

CAUTION:
- Visually check the clip, pawls and metal clip for deformation and damage during installation.
Replace with new ones if necessary.
- When installing front pillar garnish, check that clip and metal clip are securely fitted in body panel holes, and press them in.