Seat Cushion: Service and Repair

FRONT SEAT


SEAT CUSHION : Disassembly and Assembly


DISASSEMBLY
1. Remove the seat cushion outer finisher.





1. Remove the metal clips and pawls, and then pull out seat cushion outer finisher.

Triangle: Pawl
Square: Metal clip

2. Disconnect the seat control switch, lumbar support switch harness connector.
2. Remove the seat cushion front finisher.
3. Remove the lap pretensioner. Removal And Installation.
4. Remove the seat cushion inner finisher.





1. Remove the seat cushion inner finisher fixing screw (A).
2. Remove the metal clip and pawls then pull out seat cushion inner finisher.

Triangle: Pawl
Square: Metal clip





5. Disconnect the seat cushion heater unit harness connector (A).
(with heater seat model only)

Arrow: Vehicle front

6. Remove the seat cushion trim and seat cushion pad.
1. Remove the seat cushion retainer.
2. Remove the seat cushion trim and seat cushion pad from the seat frame assembly.
3. Remove the hog rings, and separate the seat cushion trim and seat cushion pad.
7. Remove the seat cushion finisher inside.
- Remove the seat cushion inner finisher inside (front, rear).
- Remove the seat cushion outer finisher inside (front, rear).
8. Remove the following parts after removing seat cushion finisher inside.
- Seat cushion climate controlled seat unit (with climate controlled seat model only). Climate Controlled Seat Unit.
- Seat control unit (driver seat only). Service and Repair.
- Remove occupant detection system control unit. Removal And Installation.

ASSEMBLY
Assemble in the reverse order of disassembly.

CAUTION:
Install the hog rings of seat cushion trim in position, and then securely connect the trim or trim cord with the pad side wire.